Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old Sep 22, 2005, 02:50 PM
kryptoniteRxn is offline
Find More Posts by kryptoniteRxn
NO NO come back...spLAT!!

How come my servo lead connector doesn't fit???


HOw come my mini servos doesn't fit into my Rx (JR R700), i checked and could see that each servo connector has a horizontal extention that looked like it could only be fitted into a special Rx with side cut/groove slot. can i just cut this pertruding??? and fit em in my rx?
Sign up now
to remove ads between posts
Old Sep 22, 2005, 02:54 PM
Tintin is offline
Find More Posts by Tintin
Registered User
Tintin's Avatar
I guess your servos are fitted with futuba connectors so yes you can cut but make sure you then put them in the right way. The horizontal extension is there to make sure you do but not used by ie JR.
Old Sep 22, 2005, 02:56 PM
kryptoniteRxn is offline
Find More Posts by kryptoniteRxn
NO NO come back...spLAT!!
oh, i knew it was for the pos neg reverse polarity protection but didn't know if could safely cut it out. but eh, the grooves are about to be removed...gone!


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
e-sky reciever doesn't fit my motor benzza Micro Helis 3 Jun 28, 2005 08:52 AM
my wing doesn't fit concretefingers GWS (Grand Wing Servo) 0 Aug 23, 2004 04:00 PM
How do I tighten down my prop if the motor doesn't stop turning? ManWithNoName Power Systems 5 May 17, 2004 08:30 PM
Bought 2 GWS Park servos, universal connector doesn't fit my JR 610M Receiver Fred Methot Radios 0 May 22, 2003 09:27 PM
how to twist my servo leads? yb2normal Power Systems 25 Jul 23, 2001 11:49 PM