Thread Tools
May 09, 2002, 08:07 PM
Flt 76..N.bound..feet dry
AllenS's Avatar

More Pictures of another Sportwin


3/4 front view
Sign up now
to remove ads between posts
May 09, 2002, 08:08 PM
Flt 76..N.bound..feet dry
AllenS's Avatar
side view
May 09, 2002, 08:09 PM
Flt 76..N.bound..feet dry
AllenS's Avatar
3/4 rear
May 09, 2002, 08:11 PM
Flt 76..N.bound..feet dry
AllenS's Avatar
bottom view
I need the different colors for contrast
May 09, 2002, 08:17 PM
Flt 76..N.bound..feet dry
AllenS's Avatar
After the repairs from second flight bad launch, I fixed the gaps under the cockpit hatch. I will have to use Buddly6s magnet technique to hold it down. First flights I used tape

Al Sharog

May 09, 2002, 08:42 PM
Senior Member
Paul Penney's Avatar
allen,

glad I could help. Its always nice to have a stick of magnets handy in the shop.

BTW, did you attach tail surfaces and cover or cover first without tail surfaces?

Best regards,

Paul

www.canadianmodelsupply.com
May 09, 2002, 10:42 PM
small electrics r BIG FUN
Hi Al

That's perrrty ! Does it fly as well as it looks ?

Best Regards

Al
May 10, 2002, 06:42 AM
Tork it or Dork it
Ryan Nau's Avatar
Thats real nice! Nice covering job. It makes me want to get my plans out for it and start building it.
May 10, 2002, 07:46 AM
Flt 76..N.bound..feet dry
AllenS's Avatar

Thanks, it's all trick photography.


Buddly - The plane was completely assembled, then covered.

Al P - Two flights, the first was the one that convinced me the plane was a "Keeper", unfortunately the second launch was not a good one. Repairs are almost complete, if the weather Dudes had not been wrong, it would have been ready today. They said wind, so I elected to straighten out my PC (dead CD drive) & load the digital camera software. So wouldn't you know, calm.

Best

Al Sharog
May 10, 2002, 08:39 AM
Mr Mootsie
Mr Mootsie's Avatar
nice job Al. I see you incorporated the skeg and aileron servo underneath. It is the way to go.....lots more room inside.

BTW, those magnets work like a champ. I used them as well.

cheer,
tim


Thread Tools