Thread Tools
May 04, 2002, 02:09 PM
Registered User

Use 6 channel transmitter with 4 ch rcvr?


I have a 4 channel receiver and wonder if I can use it with a 6 channel transmitter. If I do, which transmitter controls will be active on the receiver. I assume it will be the two joysticks. Is this right?
Sign up now
to remove ads between posts
May 04, 2002, 02:23 PM
Registered User
senor_paco's Avatar
Sure will be. remember functions 1-4 are on the joysticks. Flaps, gear and whatever else use the higher channels.
May 05, 2002, 08:28 AM
Dave Segal
It should not be a problem. Look at your transmitter instruction manual and whatever function channel 1 does on your transmitter then plug the appropriate servo into channel 1 of your receiver. Just do that for all of the channels and things will be fine.

Dave Segal


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Wanted WTB: 4-6 channel radio, with reciever, charger, and servos (prefer Futaba) super_nova Aircraft - General - Radio Equipment (FS/W) 2 Oct 19, 2005 08:03 PM
WTT: JR Quattro Lite 4 channel transmitter with channel 35 crystals livinma1 Aircraft - Electric - Airplanes (FS/W) 5 Jun 30, 2004 08:32 PM
FSFT: JR Quattro Lite 4 channel transmitter with pair of channel 35 crystals [ 1 ] livinma1 Aircraft - Electric - Airplanes (FS/W) 0 Feb 02, 2004 08:51 PM
FS: JR Quattro Lite 4 channel transmitter w/ 2 ch 35 crystals. livinma1 Aircraft - Electric - Airplanes (FS/W) 5 Jan 23, 2004 07:30 PM