Thread Tools
Old Aug 17, 2005, 04:13 PM
jasoncy2k is offline
Find More Posts by jasoncy2k
Trying to learn 3D flying

My Tail rotor won't spin, how to mix? Help


Hi,

I am a newbie into Micor heli. I have a Dragonfly FP with seperate electronics.
The TX is GWS 4channel, RX is GWS 6 channel. GWS PG-03 Gyro.

My question is that my tail rotor won't turn. When the heli tail spins, I can see the red light on the GWS Gyro I guess indicating that it's spinning. But the tail rotor won't spin. I have tested the tail motor to make sure it's good.

So do I need to mix the rudder (channel 4) ? Don't know how this works, any help is appreciated.

--JC
Sign up now
to remove ads between posts
Old Aug 17, 2005, 04:18 PM
TMorita is offline
Find More Posts by TMorita
Registered User
You can't do mixing with a GWS 4 channel radio.

There's ways to do mixing on the heli including a separate mixer, a TREC ESC, etc or use a HH gyro.

This is all explained in the EHBG.

Toshi


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! Blade CP//DD mod and tail motor won't spin! n3ok318 Micro Helis 3 Jan 01, 2006 10:34 AM
Question Help!!!!!!! Dragonfly main rotor won't arm!!!!! Ekim Micro Helis 2 May 04, 2005 12:32 PM
HB - my tail rotor stopped! Help! albireo Micro Helis 6 Aug 24, 2003 09:26 PM
My Tail Motor won`t engage kushal_22 Micro Helis 9 Aug 17, 2003 11:10 AM
Tiger Moth Help - My heat sink won't fit... DennisG Parkflyers 13 Nov 19, 2002 05:35 PM