Thread Tools
This thread is privately moderated by Jack Crossfire, who may elect to delete unwanted replies.
Dec 05, 2021, 08:27 PM
Registered User
Jack Crossfire's Avatar
Thread OP
Discussion

Another repair day


New ball links were printed at 220C. Careful use of the pliers got them on without delaminating. Ground a flat in the pushrod to aid the pliers. Tried lubricating the ball joints to try to keep any material from wearing off. Disappointing how fast PLA stretches & comes loose. Another idea might be TPU ball links.

Then came the well loved paw controller with water damage to the steering traces & a ground trace. Nearly the entire circuit is now potted. Removed an unused bodge wire. The power switch has a developing sticking in the off position which can be overcome by pulling it out. This too is probably water damage.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Yippee! Another experiment with my 90 mm Stealth Proto - "May Day Flying" jofro Large EDF Jets 57 Jul 07, 2021 10:21 AM
Help! Another 9X repair! Toomb Raider Radios 6 May 18, 2016 03:23 PM
Discussion It's time for another build/repair day... rampman Gilbert Quiet Flyers (Arizona) 21 Oct 16, 2009 01:29 AM