I was cleaning the basement of a massive mess of old boxes totes and such. Came across a HK wing that I never even took out of the package. It is approximately 6 feet long and at the middle is close to 2 feet wide.
I also came across a kit that converted a slow stick and converted it to a ultralight look.
I am looking for advivce, help and most of all any wisdom anyone can send !
Thanks in advance !

I have a Futaba T6ex 6 channel tx and Futaba R 17 receiver would that work for a ppg ? I am retired and can use a lot of time on this project but not a lot of$. had to sell my drone early this spring so there is nothing to fly.
the motor I have is a Hobby King Donkey ST 3511, 810 KV, a hobby King 30 amp esc with a 5.5 V-3 amp bec for 2 to 4s lipo. 2 -3S 11.5v batteries new never used got them in 2015. I also have a HW BQ-2006 programmer.
none of these have been used just need to find out if they are sufficient for this project