I begin to glue fusalage parts ... for moment balsa pieces.

Continue ...

A good day. I glue pieces of fuselage. I made a rig for sanding edge of ruder and elevator.

Pipes installed ...

Second fuselage continue ...

Ready for sanding both fuselages. Step 28. Tool for beveling edge for elevators and rudders are ready. Begin prepar to install servo and rods. At this moment one fuselage have 111 grams, other 113 grams (before sanding, only wood and pipe).

Sanding bevel edge of elevator - piece one from three. Prepare table for wings - central part.

Begin extract piece by piece, preparing for wings mount.

... continue ... Extraction of all pieces is finished. Now I have to sort them

I check if they all fit, and when I'm sure it's good I stick them.

New tools . And step 29 from manual.

Step 37 now ...

Today step 30, and after drying, have all pieces for central segment of wing.

Step 31 and begin step 32 ...

It's a good idea to check a few times before gluing. I found an error, which of course I corrected.

Step 32 finished. Begin step 33. Must cut the carbon pipe.