Small steps ... Be very careful when glue R28.1 with R28.2 !

Just receive second spinner and servo for this project ... On fuselaj just some check before glue some pieces.

Step 14 and 15 from manual ...

Step 16, 17, 18 and 19 ... Follow step 20.

Step 20 and 21, and prepare materials for next steps ...

Preparing next steps ... I removed small burrs to eliminate gaps between the parts.

Complete step 21.

Step 23 and 24.

Some pictures with motor, and check if it fit. Then step 25 completed.

Litle steps preparing step 26.

Step 26 completed.

Step 27 completed.

Some remaining images from step 26. I finished everything that was left to glue for fuselage, and I also used the balsa piece R28, before begin sanding next week.

Begin second fuselage, preparing small pieces. Little sanding to every piece.

Preparing long pieces of fuselage (cut and sanding where is necessary).