Twin boom pusher "SS Dragon" for Aerial Photography or trainer
I gotta make more room in my garage!
Here is a "Slow Stick" version of my Depron Dragon http://www.foaminfusion.com/UAV.html twin boom pusher. It breaks down very flat for shipping/transportation and the wing is 3 piece. The A tail comes apart with a pin.
It has custom landing gear and a motor riser to keep the prop off the ground. The center wing section uses kevlar thread wrapped carbon tubes front and rear and the outer panels have carbon rods front and rear that slid into the carbon tubes of the center section, you just tape the secons fron sliding off.
oh, also comes with CF servo push rods. DOES NOT COME WITH ELECTRONICS.
My Depron Dragon carries a 14 oz payload easily and with the same motor set-up this will too.
I did a post on one of my flights with here: https://www.rcgroups.com/forums/showthread.php?t=381986
It flys great (NOTE: you will need V tail mixing on your radio) .
If you want a great A/P platform already built, with EZ to find parts, here it is!
$80 plus shipping from 95630. Shipping size is approx: 36" x 16" x 6"... figure 5 lbs.
EMAIL me HERE: email@example.com
Last edited by CactusJackSlade; Jan 19, 2006 at 12:30 AM.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|For Sale||ICOM IC-R3 for Aerial Photography or Radio Scanning||Justin Jackson||Non R/C Items (FS/W)||2||Jan 19, 2007 12:24 PM|
|Sold||Twin boom pusher "SS Dragon" for Aerial Photography or trainer||CactusJackSlade||Aircraft - Electric - Airplanes (FS/W)||0||Jan 19, 2006 12:50 AM|
|need build advice for a twin boom pusher||eran_k||Foamies (Kits)||2||Aug 29, 2005 03:01 PM|
|Just posted twin boom pusher A/P platform for sale||CactusJackSlade||Aerial Photography||1||Jun 14, 2005 12:29 AM|
|71" "Slow Stick" Twin boom pusher - ready for the MAIDEN FLIGHT!||CactusJackSlade||Aerial Photography||3||Feb 19, 2005 05:27 PM|