Carbon Push Rods for 60" DLG - RC Groups
Thread Tools
Jun 05, 2005, 05:07 PM
Registered User

Carbon Push Rods for 60" DLG

What is a good size solid carbon push rod to use for 60" DLG?

0.5mm (0.02") or 0.8mm (0.031")? not including the diameter of the sleeve tube.

Which one does XP-4 use? The website says 0.03". But my friend measured his and said 0.02".

Can I really expect to save some significant tail weight by going with carbon rods instead of 0.031" wires?

Also, has anyone break a carbon rod in flight before?

Thanks for answering so many questions.
Sign up now
to remove ads between posts
Jun 05, 2005, 06:32 PM
Registered User
I used .015 wire on my "Spin Doctor" Dlg I designed with no problems. I used the #23 bondable teflon tubing full length from servo to control surface.

Jun 05, 2005, 09:05 PM
Registered User

The XP-4 uses .030 which in reality is .025 to .027. #20 etched teflon for housing.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Micro push rods for foam Roto zeenon Foamies (Kits) 2 Feb 27, 2003 09:34 PM
Carbon Fiber Rods for Wing Spars Jim Young Power Systems 7 Dec 21, 2001 12:52 PM
Source for Carbon Fiber rods Twmaster Parkflyers 11 Sep 27, 2001 12:23 AM