Thread Tools
Apr 15, 2002, 09:16 PM
Green Member
FX1SUB's Avatar

Tryin to build my EZ-400G...Help!

Well I'm about to get started and I have a couple of questions.

1st: What glue to use? The directions say CA or epoxy...Should I just go to Home Depot and pick up some generic epoxy?

2nd: It comes with a three piece wing, when I matched up the end pieces with the center piece, they don't seem to fit flush. One side has a gap and the other will touch in the center but not on the edges. This would make it quite difficult to glue together? should I sand it down? Is this normal for an ARF?

As you can probably already tell, I have no experience building models....Amazing, I've built a telescope in a truss tube configuration that's 6 feet tall but this 27oz plane is already kicking my butt. Here's a link to the plane


Sign up now
to remove ads between posts
Apr 17, 2002, 03:35 PM
Registered User


i used epoxy on mine as far as the wing mine was like that, i just glued it like it was just make sure it is straight mine flies great and sturdy as all get out hope you have fun with it,how do you like the directions hehehehe kinda sketchy

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help me build my 40" bird button 3D Flying 1 Jan 30, 2005 11:21 AM
Idea Help to build my FIRST plane Jarg Beginner Training Area (Aircraft-Electric) 9 Sep 20, 2004 02:24 PM
HD3D construction thread (Help me build my new plane!) Blackhawk3D 3D Flying 144 Jun 24, 2004 12:44 PM
help me build my new superstar ep. i am having problems someone special Parkflyers 25 Jan 19, 2003 05:38 AM
About to put together my EZ-400G FX1SUB Parkflyers 14 Apr 21, 2002 06:10 AM