Thread Tools
This thread is privately moderated by Jack Crossfire, who may elect to delete unwanted replies.
Oct 28, 2020, 06:28 PM
Registered User
Jack Crossfire's Avatar
Thread OP
Discussion

3 channel paw controller #2


Obviously a lot more than a few tweeks happened. The mane event was moving the speed buttons to the sides & the power button to the back. The button spacing was dictated by mechanical clearance rather than ergonomics.

This would be a lot easier with tact buttons, but the lion kingdom insisted on something more durable. These MHPS buttons could have gone down to 6mm per side without a major increase in cost, but the lion kingdom wanted to finish. Despite every effort, hot gluing all the hot glued bits is still a buster. What's needed is a fine pointed hot glue gun.

There's some debate about whether the pinky grip should go all the way across. The 2 halves don't line up, making it look awful.

Too bad there isn't any more investment in lion machine interfaces. They all standardized on the game pad, 20 years ago. There were a few voice, gesture startups, 10 years ago.
Last edited by Jack Crossfire; Oct 28, 2020 at 06:56 PM.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
New Product JJ-H27 2.4G 3.5 Channel Remote Control RC Airplane With Gyro RTF TS Banggood RC Scratchbuilt Indoor and Micro Models 9 Oct 10, 2013 09:28 PM