Thread Tools
This thread is privately moderated by Jack Crossfire, who may elect to delete unwanted replies.
Sep 19, 2020, 05:17 PM
Registered User
Jack Crossfire's Avatar
Thread OP
Discussion

Blower installation


A new filter, maximum load test, & the nozzle actually worked. The blower didn't entirely fit in the nozzle, but going halfway seemed to be enough.

The outlet was left scotched on so if the air comes out too fast, the outlet diameter can be changed. A motorized outlet was deemed unnecessary & would have required upsizing the rest of the nozzle. A bayonet mount for the outlet would have been nice.

The only glitches were the IR getting obstructed by the cables & no protection from the nozzle hitting the wall. The air comes out faster than expected. The bearings & contortions didn't impede the airflow as much as expected, but that's why it's a fighter jet nozzle.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Poll Should whistle blowers be protected? Douwe Life, The Universe, and Politics 8 Feb 16, 2017 02:10 PM
Discussion Bouncy house blower motor reversed direction ramman347 Electric Motor Design and Construction 2 Sep 23, 2015 09:44 PM