Thread Tools
Sep 05, 2020, 12:10 AM
Retired Electronics Specialist
vollrathd's Avatar
Thread OP
Alert

More receiver switch issues!


One of my RC club mates pulled these two switches out of his new 30 cc gasser, and installed a pair of those Digikey toggle switches I've posted elsewhere in RCGroups.

Naturally, I was curious about these two switches, and checked them out on my SwitchIR meter. One showed 1100 Milli-Ohms, the other ranged from 1500 MilliOhms to OPEN CIRCUIT ON THE SWITCHED RED WIRE!

My RC club member is very lucky that he didn't lose his model.

Please note that this is NOT a repeat of another posting by vollrathd in this thread. These two switches are different units than the other posting.
Last edited by vollrathd; Sep 05, 2020 at 09:03 AM. Reason: 1100 not 670 Milli Ohms
Sign up now
to remove ads between posts
Sep 14, 2020, 05:51 PM
Entropy is happening!
Jim.Thompson's Avatar
Thanks for this notification Vollrathd. It serves for me as a reminder to go back to your switch IR meter thread and get motivated to build one.

https://www.rcgroups.com/forums/show...icrocontroller

A recent group of RF link control failures have revealed the need for such a piece of equipment.
Last edited by Jim.Thompson; Sep 14, 2020 at 06:02 PM.
Oct 24, 2020, 03:58 PM
Entropy is happening!
Jim.Thompson's Avatar

Electronic Receiver Switch - another Vollrathd design!


I make these up and use a simple shorting jack or small switch:

https://www.rcgroups.com/forums/show...eceiver-switch

Failure mode is on.

Thanks again for this Vollrathd!

Jim


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Alert Receiver Switch Issues! vollrathd Crash Discussion 0 Jul 27, 2020 05:16 PM
Discussion Turnigy Receiver Controlled Switch issue faheja Night Flying 39 Mar 03, 2020 04:26 PM
Discussion Creating a Better and more reliable Power Switch for our RC receiver switch. lazy-b DIY Electronics 15 Aug 12, 2008 02:06 AM
JMP Combo Receiver issues (and more) Jerry Rose Scratchbuilt Indoor and Micro Models 8 Jun 13, 2004 08:43 AM