Thread Tools
This thread is privately moderated by old4570, who may elect to delete unwanted replies.
May 08, 2020, 02:10 AM
Registered User
old4570's Avatar
Thread OP
Discussion

4th and final spinner ..


spinner No4 (0 min 45 sec)


Looks like the 4th time is the charm .

No mods needed to fit the prop .
Also fits the Decat with a rubber band mounted prop .

Looks like my first print project worked out ok ! Yeah , it's Mikey Mouse . But it does the job .
Especially since this is my very first 3D design and print effort .
It was very much a 4 print evolution and a 7 stage design effort .
Now to move onto something else ..

Volantex Super Cub spinner .

Designed with the rubber band post/driver in place .
The nose cap and lower spinner assembly need to be drilled out to fit the shaft .
I drill the cap ( retaining cap ) to 2.5mm and then run a threading tap into it .

Not sure about printing such a fine thread (?) might be possible (?)
I have included the STL for non commercial purposes .
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! Spinner dimensions for FMS 1400 P-51 spinner odiewan Electric Plane Talk 6 Mar 17, 2018 08:53 AM
Contest PVMAC (Prado) AMA/& Classic Pattern - October 3rd and 4th TonyF Classic Pattern Flying 6 Oct 05, 2015 03:09 PM
Article The 4th Annual Clover Creek Fly-in Jim T. Graham RC Flight Events 2 Sep 21, 2015 12:13 PM
Discussion 4th Motor problem that's NOT 'the' 4th motor problem... Rhys Porter Multirotor Drone Talk 8 Jun 30, 2012 02:35 AM
Video Pilot-1 4th Scale Waco Final Edit Jason Cole Electric Plane Talk 5 Nov 27, 2009 01:34 PM