B-25 Mitchell & F7F Tigercat Build
Hi, i hope to show you the progress of the construction of these two models over the next few weeks.
Two 480 standard brushed motors
Two 3:1 gearbox's
One 25amp speed controller
two micro servos (ailerons)
one mini servo (elevator)
all up weight 2.5lbs (i hope)
Same as above apart from
Also you might see some progress of my ME262
Keep your eyes peeled
Last edited by philip noel; May 29, 2006 at 02:27 PM.
Wings, inboard and outboard panels, 1/16" balsa ribs, front spars 1/8" sq spruce, rear spars 1/8" sq balsa.
Wing skins 1/16" sheet balsa, main wing and fuse former (two) 1/16" plywood.
Glued using cyno.
Wing panel construction
Hi, just thought i had better let you see how the wing panel in made.
Plan stuck down and False L.E & T.E stuck to building board, these are cut so that you get the correct wash out on the wings.
Inboard, and tip rib stuck to LE & TE and upper spars fitted (Note wing is built upside down - you will see why later)
All ribs fitted and lined up with top edge of LE & TE.
Lower spars fitted.
It is now ready to be rubbed down ready for skinning.
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|B-25 Mitchell JR models||surfer||Scale Kit/Scratch Built||61||Aug 09, 2007 05:09 PM|
|Mini B-25 Mitchell scratch build||zen4013||Scale Kit/Scratch Built||0||Jan 16, 2005 09:29 PM|
|Dare B-25 Mitchell (conversion)||KSU Flyer||Parkflyers||154||Jan 10, 2005 11:02 AM|
|Looking for a 3 view of a B-25 Mitchell!||Willmsy||Scale Kit/Scratch Built||3||Jul 15, 2003 02:51 PM|
|B-25 Mitchell||Fraser||Scale Kit/Scratch Built||1||Jul 31, 2001 11:31 AM|