Thread Tools
Apr 18, 2020, 10:51 AM
Registered User
Thread OP
Discussion

rfu and x10 in x9


Jim
i have a quick question that i cannot find or remember the answer to.
will the RFU send ten channels to the x10. I know i can remap the 9 and 10 pins to emulate channels one through eight but can i asign channels 9 and ten to switches on the tranis X9 with exernal rx set to ppm with the jr module
thanks
don
Sign up now
to remove ads between posts
Apr 18, 2020, 02:10 PM
The RFU outputs the channels from your transmitter. If your transmitter outputs 10 channels then you will get 10 channels out of the RFU. You will need to use XJT-D16 mode for the Taranis if you want more than 8 channels. PPM is limited to 8 channels.
Apr 18, 2020, 03:05 PM
Registered User
Thread OP
thanks jim


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
New Product RFU - diversity receiver for X10+ JimDrew Xtreme Power Systems 76 Dec 05, 2017 02:57 AM
New Product Syma X9 Flying Car Two -in-one Quadcopter - Quadcar 4CH 6-Axis artlovesart Mini Multirotor Drones 27 Jun 08, 2016 01:01 PM
Discussion X10 to RFU Connection T-ster Xtreme Power Systems 2 Jun 05, 2016 04:08 PM
New Product 【 Reviewers Wanted】Syma X9 Fly Car 2-in-1 RC Quadcopter - Exclusive Thunder Blue tenergyrc Multirotor Drone Talk 7 Jan 27, 2016 05:22 PM
In flight ideo. x10 vs cmos board & transmitter erashby Power Systems 11 Jan 06, 2002 08:48 PM