Set of Robart air for gear doors etc. Total length is 3 7/8 without clevis attached. Total arm travel without clevis is 1 1/8 Arm is 3/16 long when fully closed without clevis attached. Will trade for a set to fit my Topflite P-51- 1/5 scale inner gear doors or u can purchase these for $40.00 shipped. Retail was $60.00

What size do you need?,, ya know you can shorted the throw with a couple wheel collars if that's the problem

Originally Posted by scale_only

What size do you need?,, ya know you can shorted the throw with a couple wheel collars if that's the problem

Thanks for reply. Mine would be the about the perfect length if it was not for the 1 in. clevis needed to attach to closing horn. Most robart cyl. have a flat spot on travel arm with a hole drilled through so a clevis isn't needed. Cant cut an inch off these so what i need is a set that when closed is 2 1/8 to 2 1/4 long from bottom of cyl. to tip of clevis or center of pre drilled hole in shaft and 3 3/8 when when fully extended. Any help is appreciated.....Dan