Thread Tools
This thread is privately moderated by PittSpecial, who may elect to delete unwanted replies.
Nov 25, 2019, 01:27 PM
Right Rudder
PittSpecial's Avatar
Thread OP
Discussion

Summary on the 3D Printed 9-Cylinder Engine & E-Flite AT-6 Texan with PZ 480


Hello good people!

As the title says, this is perhaps the Finalized Summary on the:

3D Printed 9-Cylinder Radial Engine & E-Flite AT-6 Texan with PZ 480.

I believe that I did a good job providing the Summary over at RCUniverse and you all can read up on it at:
http://www.rcuniverse.com/forum/arf-...l#post12565560

For those truly interested then, you can visit Peter's Web Site over at:
http://motorattrappen.de/


Some Teaser Pics:








Last edited by PittSpecial; Nov 26, 2019 at 04:17 PM.
Sign up now
to remove ads between posts
Nov 27, 2019, 11:56 AM
Right Rudder
PittSpecial's Avatar
Thread OP

Flight Demonstration of my E-Flite AT6 Texan using Park Zone 480 (960Kv)


Guys,

A few have PMed me about a nicer Video showing Take-Off and most importantly the Landing of my E-Flite AT-6 Texan using the Park Zone 480 (960Kv) Motor. The other Video if you recall was full with lots of instability and movement so, I mounted my 8 year old NIKKON Coolpix S9001 HD Camera on-top of my Cowboy Hat!

I believe that I was successful in ALL accounts and have demonstrated the capabilities of the Park Zone 480 motor (Black Can 960Kv, normalized to 910Kv per Dr. Kiwi).

Without any further delay, here's the Video:

3D Printed 9 Cylinder Engine Project E Flite AT6 Texan 11 27 2019 (7 min 47 sec)


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Engine choice for Top Flite 60 AT-6 Texan MINI30BOB Engines 15 Nov 25, 2015 05:48 PM