Thread Tools
Nov 19, 2019, 10:38 PM
Registered User
Thread OP
Discussion

Matek 405wing PPM input - connect DJI ocusync air module


I have flight controller Matek 405. It receives channels (rudder, throttle, roll, pitch etc) from receiver connected to SBUS.

DJI ocusync air module has sbus output for passing through receiver. It also has PPM output for 2 channels - head tracking.

Currently Iím connecting PPM output from it to PPM->pwm converter, then to servo reverser, then to camera servos.

Is it possible to somehow connect PPM as additional receiver to Flight Controller? That surely would clean up my setup
Sign up now
to remove ads between posts


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion DJI Ocusync Air System Battery Requirement Synthetic11 FPV Equipment 0 Jul 09, 2018 07:29 PM
New Product DJI Mavic Air - Upgraded Mavic Pro bit bigger than Spark body - No Ocusync!! :( sevet Multirotor Drone Talk 57 Jan 26, 2018 12:26 PM
Question Latency from Tx module PPM input to Nano Rx PPM output FlyingW Xtreme Power Systems 4 Jan 07, 2018 01:49 AM