Thread Tools
Oct 20, 2019, 12:36 PM
Registered User
Thread OP
Help!

Server power supplies won't power up.


Doing two HP server power supplies in series. Testing them before I float one and link them but they aren't turning on. Soldered a resistor between pad 33 and 36 just like every faq I've seen. Fan turns on when I plug them in but no led and no output power.

Any ideas before I just say screw it and buy a 24v psu? Need at least 650w, 24v for my Hobbymate charger to hit 15A x2.

Maybe I just got 2 bad ones but I dunno.

Sent from my COR-L29 using Tapatalk
Last edited by scottydsntknow; Oct 20, 2019 at 12:59 PM.
Sign up now
to remove ads between posts
Oct 20, 2019, 01:24 PM
Registered User
Thread OP
NVM... I need to work on my small soldering... It is pin 33 and 36... I just needed to resolder and use a smaller iron and solder. Both power on and full power now.

Sent from my COR-L29 using Tapatalk


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Mini-HowTo Dell PowerEdge 2950 Server Power Supply Unit - How to set up. guyfawkes Batteries and Chargers 16 Jun 06, 2018 12:49 PM
Help! howto power up compaq server power supply jezza56 DIY Electronics 5 Jan 24, 2017 09:28 AM
Discussion HP DL380 power supply won't power on timmyjane Batteries and Chargers 2 Mar 07, 2016 02:19 PM
Discussion I make server power supplies, buy one from me you won't need to modify? DeltaPSU Batteries and Chargers 24 Mar 11, 2015 01:24 AM
Discussion Dell server power supply won't provide more than 16amps? davekra Batteries and Chargers 11 Nov 13, 2013 12:11 PM