|
|
|
Discussion
Question on new build
I am building a alien mr Steele version with me Steele pdb. I’m running Lumenier motors, kiss 24 amp esc’s and a version 1 kiss flight controller. I’m going to run a unify pro hv.
I have version 2 of the new mr Steele pdb. Just to clarify, when setting it up I plug the white wire into port 2 and the black wire into port 1! Is that right? Also, since I am running a unify pro hv that states it supports 6-22v. I am assuming I will bridge solder the two pads which will output 7 volts from the mr Steele pdb? Is this right? I haven’t built a quad in about two years and things change often. I am just trying to prepare myself before I start building! Thanks in advance! Andrew |
|
|
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Discussion | A few questions on a new build | Hifire | Beginner Multirotor Drones | 3 | May 27, 2018 06:55 PM |
Discussion | Radiolink at9 question on new build | rinker312 | Multirotor Drone Electronics | 3 | Jan 07, 2018 06:41 AM |
Discussion | Question on new build | Leftyatm | Beginner Multirotor Drones | 0 | Nov 18, 2017 11:28 AM |
Discussion | Question on new build, Naze32 overcraft pdb | Leftyatm | Mini Multirotor Drones | 1 | Feb 24, 2016 05:16 PM |
Question | Questions on building my new flying wing and on the J250... | Picoflyer | Flying Wings | 3 | Jun 14, 2004 12:58 PM |