|
||
Thread OP
|
Quote:
Try v1.1.3 from frsky download page Or first which version of the qx7 do you have? Otherwise https://www.frsky-rc.com/taranis-q-x7-3/ Make sure to flash the right firmware! |
|
|
Last edited by Paul1969; Jun 23, 2020 at 11:54 AM.
|
|
|
|
|
|
I have this one. https://www.frsky-rc.com/product/taranis-q-x7-2/
Only two XJT firmware is avaliable, on is pre 2.0 the other is 2.1 |
|
|
|
||
Thread OP
|
Quote:
Here it is. |
|
|
||
|
|
|
Yes I am using that one. But it does not bind. Is there a connection between not binding and the actual transmitter firmware? By the way I've also selected US in transmitter settings.
Only thing that comes to mind is that the R1F's are loaded with EU firmware and can not be reverted to FCC. I won't go into flashing my XJT with EU firmware though. As I am afraid of not being able to flash FCC anymore. |
|
|
|
|
Thread OP
|
Ok than this version should work.
I have the eu version and it binds. https://www.frsky-rc.com/xsr-m/ Use the fcc version My r1f was delivered with fcc version and I flashed it with eu version |
|
|
|
|
|
I've used D16, I ve also tried D16 mode with 8 channel or 16 channels. With 16 channels I've tried 1-8 with or without telemetry, 9-16 channels with or without telemetry. I've also tried several non fport firmwares with accst <2 and >2 versions. At this point I just give up. I am pretty happy with r-xsr's and d8 minis. Shame the price is two times these. I am currently using the r-xsr's with fport firmware and they work great.
|
|
|
|
|
Thread OP
|
Flashed today my R1f receivers with V2.1.0 firmware and all is working fine.
https://github.com/FrSkyRC/Firmware-....1.0_FPort.zip |
|
|
|
||
|
Quote:
|
|
|
||
|
|
Thread OP
|
The r1f needs xsr fport firmware
|
|
|
|
|
|
Hi, I successfuly connected R1F to Jumper T16 with multiprotocol (FW F.Port 180111 EU LBT). I see many sensors, RSSI is about 95dB. It's fine. But - I cannot set this Rx to Betaflight with GEPRC Stable F411. I set SBUS/Fport, halfduplex = on but still no move on sticks... Where is the problem? This receiver works me fine with Holybro Kakute F7.
|
|
|
|
||
Thread OP
|
Quote:
You need the uninverted signal but telemetry won’t work. |
|
|
||
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
New Product | Jumper R1 Mini Receiver 16CH Sbus RX Compatible Frsky D16 Transmitter Radio Remote Co | alex_nikiforov | Banggood.com | 7 | Dec 02, 2020 05:14 PM |
New Product | NR502T-F2 16CH SBUS RC Mini Receiver Support Telemetry RSSI Compatible Frsky D16 | Merch | Banggood.com | 2 | Sep 14, 2019 08:05 AM |
New Product | XR401-B3 XM 16CH SBUS RC Mini Receiver Support RSSI Compatible Frsky D16 | Merch | Banggood.com | 2 | May 29, 2019 05:56 AM |