Thread Tools
Sep 22, 2019, 04:35 PM
Registered User
Klemen P's Avatar
Thread OP
Quote:
Originally Posted by Umi_Ryuzuki
The hull is looking really nice.

thank you !
Sign up now
to remove ads between posts
Sep 25, 2019, 03:02 AM
Registered User
Klemen P's Avatar
Thread OP
It was a bit of a pause now because there were other things in between, and this week I am continuing on the boat again.

A new cabin is being built because the previous one was too small and too short.
Since I found another important detail in the picture of the right one, I had to make these on the lower hull too.
Work is also continuing on the upper deck.
Sep 27, 2019, 11:45 AM
Registered User
Klemen P's Avatar
Thread OP
..,.............................................
Sep 28, 2019, 09:02 AM
Registered User
Klemen P's Avatar
Thread OP
Every day more and more
Oct 01, 2019, 06:00 PM
Registered User
Klemen P's Avatar
Thread OP
The initial momentum is slowing down, but there is too much to do in the fall, so I am progressing more slowly
Btw, I sell a room of dust
Oct 02, 2019, 09:08 AM
Registered User
Klemen P's Avatar
Thread OP
Today we have a rain..great day for modeling
Unfortunately, the carriers will not be two-part, because I simply do not know how to put them in order to be strong enough.
Will need to be caught by the angle measure and hope for the best.
Otherwise, we will be sawing.
Well, I hope don't have to
The profile of the wing will be Clark Y. If the airplane flies,must this boat too
Oct 02, 2019, 04:22 PM
Latitudes vs Attitudes
Bob Gaito's Avatar
Klemen, I haven't commented in a while-the Kometa looks amazing-thanks for a great subject..BTW Solvenia is beautiful- I was in Koper last year-I'd go back in a heartbeat!
Latest blog entry: Mark V Navy Seal SOC
Oct 02, 2019, 06:12 PM
Registered User
Klemen P's Avatar
Thread OP
That's nice to hear
Yes, Koper is by the sea, I am further north in the Alps approx. 230km from Koper
btw,today was a very productive day
Oct 07, 2019, 10:28 AM
Registered User
Klemen P's Avatar
Thread OP
This wings is really difficult work
therefore, it is more friendly to work on the upper deck
Oct 12, 2019, 10:21 AM
Registered User
Klemen P's Avatar
Thread OP
After two months and a half of work, hydro roughly looks like this
comments and critiques / improvements ....desired
Last edited by Klemen P; Oct 12, 2019 at 11:36 PM.
Oct 12, 2019, 08:42 PM
Registered User
Gravman's Avatar
Beautiful model. It will look great flying across the water.
Latest blog entry: Myrtle Corey
Oct 13, 2019, 07:47 AM
Registered User
There's nothing rough about this KlemenP. What colour scheme is planned? Flying Dolphins Blue/Yellow would look good.

Regards Ian.
Oct 13, 2019, 12:25 PM
Registered User
Klemen P's Avatar
Thread OP
Quote:
Originally Posted by Circlip
There's nothing rough about this KlemenP. What colour scheme is planned? Flying Dolphins Blue/Yellow would look good.

Regards Ian.
Yes,but without yellow colour
It will be this scheme....ex Yugoslav -Krila Portoroža Koper(which is means.. ..Wings of Portorož...and Portorož is touristic city by the sea in Slovenia)
Last edited by Klemen P; Oct 13, 2019 at 12:31 PM.
Oct 14, 2019, 08:01 PM
Registered User
Klemen P's Avatar
Thread OP
That's all for now..

Now i have to take a little pause and rest



See you later guys
Oct 15, 2019, 08:12 AM
Registered User
Klemen P's Avatar
Thread OP
Modeling and making some nice models is the best

Making of the windows on Rc hydrofoil (15 min 41 sec)


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Build Log 1:20 RHS 70 Shearwater Hydrofoil scratch build CaptDH Scale Boats 30 Dec 24, 2016 12:07 PM
Discussion Naga - 2m Class Trimaran - First Hydrofoiling Attempts Multihull Sailboats 9 Dec 11, 2016 05:11 PM
Discussion non aircraft related, but rather hydrofoil related Blackrat Composites Fabrication 8 Feb 15, 2016 03:38 PM
Discussion Hydrofoil video Gravman Dock Talk 1 Feb 12, 2016 12:04 AM