Shop our Airplanes Products Drone Products Sales
Thread Tools
Mar 18, 2002, 11:28 AM
Registered User

Pull/Pull System for r/c


I am interested in using a pull/pull system for rudder and elevator and would like to know if you should use a servo linked to a bellcrank to drive the cables (Spiderwire) or can you connect the pull/pull wires directly to the servo with out damaging the servo drive componets? Any drawings available?

Would appreciate any input.

Thanks
Sign up now
to remove ads between posts
Mar 18, 2002, 11:38 AM
Registered User
Philipp's Avatar
I am probably doing all of the things that you should not do, but this is what I have on one plane:

43" Span, 48oz, AF 035G, 8 cell CP1700.

Using a standard HS 81 (plastic Gears) with spiderwire, 30# test tied directly to the servo arms, then crossed to make a proper exit from the plane to the rudder. I am even using a steerable tailwheel attached directly to the rudder.

I had to cut into the covering yesterday to tighten the lines up a bit, but have thus far never stripped a gear.
Mar 18, 2002, 11:39 AM
(Batteries not included.)
Dave Wenzlick / Slickraft's Avatar
Try this thread in Sport Planes forum.
Pull-Pull

Dave Wenzlick
Mesa AZ
Mar 18, 2002, 01:13 PM
fortune favours the bold
gjestico's Avatar

Pull-pull


Heres my E3D setup. Hs-85, nylon coated fishing leader.
Weighs less than putting the servo in the tail. Sorry for the poor quality picture.
Mar 18, 2002, 01:18 PM
Ascended Master
Sparky Paul's Avatar
Check this out for the smallest possible installation of puul-pull:
http://www.charlesriverrc.org/articl...er_kahudlg.htm


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
F.S. Wireless Color Camera System for R/C Mr.RC-CAM Aircraft - Electric - Airplanes (FS/W) 9 May 14, 2004 08:38 PM
any good how to books for r/c helis? adam_jorgensen Electric Heli Talk 4 Mar 31, 2002 11:05 AM
Moderators needed for R/C Groups! Andy W Electric Plane Talk 1 Mar 21, 2002 05:44 AM
Rechargeable Alkaline batteries good for R/C packs??? TopGun Power Systems 2 Sep 27, 2001 11:03 PM