Thread Tools
Old Feb 03, 2005, 05:50 AM
NickT is offline
Find More Posts by NickT
Registered User

Thoughts on my smart rx battery monitors readings?


I have installed the Irvine inteligent battery monitor on my 3dmp and am running a 4 cell 1100 Nicd.

The monitor flashes initally to tell the no of cells it picks up (four flashes).

It also shows the lowest voltage acheived during the flight.

After 2 secs or so from switch on the far right red (low indicator comes on and the bat level green also comes on indicating full charge, but flashes every few seconds. During this time I have not moved the sticks at all. Is it possible that the servos at rest would give this low reading or do I have a problem (battery not holding under static load?) or servo issues from the digital servos or something else - it could be normal for all I know!

Thoughts appreciated!

Nick T
Sign up now
to remove ads between posts
Old Feb 03, 2005, 10:39 AM
NickT is offline
Find More Posts by NickT
Registered User
No one?


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Why the extra leads on my Li-Po battery??? NoFlyZone Batteries and Chargers 4 Aug 02, 2006 10:08 PM
Update on My GWS RX Problem.. STaNgXs GWS (Grand Wing Servo) 0 Dec 31, 2004 01:06 AM
Need your thoughts on my first Brushless! DiabloKid Power Systems 8 Feb 18, 2003 11:15 AM
Your Thoughts on My Wild Idea Craig Logan Power Systems 1 Mar 06, 2002 08:35 PM
thoughts on my Eplane setup... foambattery Foamies (Kits) 2 May 31, 2001 12:17 AM