iFlight SucceX F4 TwinG Flight Controller + SucceX 50A ESC 2-6s BLHeli_32 Dshot1200 4

iFlight SucceX F4 TwinG Flight Controller + SucceX 50A ESC 2-6s BLHeli_32 Dshot1200 4-in-1 Flytower Flight Tower for FPV Racing Drone Quadcopter DIY Models
https://www.xt-xinte.com/iFlight-Suc...s-p583302.html
Specifications :

FC Specifications
MCU：STM32F405R6T6
IMU：Twins IC2689，Twins Gyros built-in（SPI）
Baro：BMP280
OSD：AT7456E
Blackbox：Blackbox logging device
5X Uarts（1 2 3 4 5）with build-in inversion
8X Dshot/Proshot/Oneshot output
8X individual ESC power/ signal pads
1X Group of Gnd/Vbat/M1/M2/M3/M4/Cur/TX
Smart audio & Tramp VTX protocol：YES（IRC Tramp）
WS2812 led Strip：YES
Beeper：YES
PDB Specifications
Input：2-6S（5-36V）
BEC：5V/3A cont


FC Firmware
Betaflight/INAV
Target：STM32F405
FC：IFRC/IFF4_TWIN_G(STM32F405)


Physical
Mounting：30.5*30.5mm，φ4mm with Grommets φ3mm
Dimensions：36*36mm
Weight：6.3g
SucceX 50A 2-6S BLHeli_32 Dshot1200 4-in-1 ESC


Features:
8 layers double-sided PCB board;
4oz 1.6mm thick power board(0.9mm copper ratio),better operating load capacity;
32bit FO51K86 MCU, 48mHz maximum clock speed;
TDK MLCC Low ESR ceramic capacitors;
Top grade NTMFS5C430NL MOSFET;
Rational layout, countersunk holes on extended solder pads to ensure PCB layer connection


Specification:
Dimension: 43*39mm
Mounting Holes: 30.5*30.5mm/Φ3mm
Weight:14.4g
Supports 2-6S lipo input
STM32F051 MCU, 48Mhz Runs BLHELI 32.X Firmware
Current sensor: Yes
BEC: No
Supports: DShot DShot150/300/600/1200/MultiShot/ OneShot etc.
Target: iFlight-BL32-4IN1


RECOMMENDATION:
No additional capacitor needed up to 5S!
To encounter back EMF and ensure the longevity of your electronics, min. 220uF Cap 35V for 4-5S, 50V for 6S on your main lead!


Package included:
SucceX F4 TwinG FC+ SucceX 50A 2-6s BLHeli_32 Flytower