Thread Tools
This thread is privately moderated by zoltansgarage, who may elect to delete unwanted replies.
Apr 20, 2019, 01:26 PM
Registered User
zoltansgarage's Avatar
Thread OP
Build Log

14 inch tug


The start of the running gear. The stainless steel rod was smaller than the hole in the propeller.
Flattened it out a bit, and threaded it. Added some silver solder to hold in place. Made a thrust bearing washer from a hard nylon type material servo arm.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools