Thread Tools
This thread is privately moderated by VicT, who may elect to delete unwanted replies.
Mar 07, 2019, 10:27 PM
Registered User
Thread OP
Discussion

Turbo Timber flight times on the Graphene 4S 2200 cells.


Iíve flown my Turbo Timber with 3S 2200 45C Admirals, 1500 4S CHNL 100 C cells and Turnigy Graphene 2200 75 C 4S cells. The performance on 4S is the most desirable but endurance is not as good as 3S. The Graphene was tested and started out at 90 percent charged. Flying consisted of 5 max power climbs to 300 ft. 5 inside loops. 15 aileron rolls and 5 takeoffs and landings. This took a little less than 5 minutes using the DX9 power on timer. Total flight time was about 7 minutes because of power off glide times. Capacity of the Graphene 4S pack started out at 90 percent and at the end of 5 minutes was measured at 31 percent remaining. So 90-31= 59 Percent in 5 minutes or 59/5=11.8 percent/minute. If flying were to stop at 15 percent remaining then a total of 90-15= 75 percent would be used. This would take about 75 %/ 11.8 %/min X = 6.35 minutes. A 3200 4S 40 C pack has been recommended by Horizon and will be tested for similar endurance time.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Lines on fpv feed but only on 4s and not all the time Minwards Beginner Multirotor Drones 4 May 17, 2017 07:10 AM
Discussion Thoughts on cell count versus Flight time Michael Paxton Power Systems 5 Aug 18, 2008 12:03 PM
Question flight times of FP EVO 1800/ Align 2200 in trex 450s p4ddy Mini Helis 0 Mar 01, 2007 07:21 AM
Discussion Flight time Apex 2200 Batt 15C? DSOUSA Mini Helis 8 Apr 11, 2006 10:16 PM