Thread Tools
Jul 12, 2019, 10:19 AM
Registered User
Lynxman's Avatar
Thread OP
Ok. Cool.
Sign up now
to remove ads between posts
Aug 05, 2019, 04:55 PM
Team Futaba
Devin McGRath's Avatar
Lynxman,

Very nice work! looking forward to putting one of these together! Ill be doing some prints on my Creality Ender 3 and some on my Ultimaker 3 extended. We will see which one handles the thin wall settings the best.

I know some of you are trying to use Cura and becoming frustrated with some of the missing features. Hopefully this may help some of you guys increasing infill or adding support to a specific area of a model. I am using the support blocker tool along with the per model settings to set specific areas of the print to have support, infill settings and a different all line count. Please see screen captures below.
Aug 16, 2019, 01:56 PM
Registered User
Lynxman's Avatar
Thread OP
I flew a new Nucking Futs today with the 3000kv inrunner. It seems faster than the drone motor variant I have. The RPM is definitely higher and it's nucking futs. BTW, I still haven't broken a single 3D printed prop on landing (or flight for that matter)
.
The Nucking Futs flight starts 10 minutes into the video, after the EL-39 and Melusine:
Afternoon at Senja MFK (17 min 47 sec)
Last edited by Lynxman; Yesterday at 10:30 AM.


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Beginner Speed 400 Pylon Racer Skullder High Performance 4 Sep 05, 2004 08:26 AM
Speed 400 "Sokol" pylon racer spitfirem9 Electric Plane Talk 6 Jul 27, 2004 08:58 PM
Wing Incidence For a Speed 400 Pylon Racer? W Cole High Performance 6 Dec 02, 2002 12:16 PM
Question for speed 400 Pylon racers Al P High Performance 3 Dec 17, 2001 06:45 PM
Article How To Test Fly a Speed 400 Pylon Racer Bruce Devisser Electric Plane Talk 0 Jul 01, 1996 12:00 AM