Thread Tools
This thread is privately moderated by old4570, who may elect to delete unwanted replies.
Dec 21, 2018, 11:44 PM
Registered User
old4570's Avatar
Thread OP
Discussion

3 Days Till Christmas ( Xmas for some )


3 Days

It be windy outside . so !

A) Did some work on the XK A800 , found a elevator issue - fixed
B) KN / WLtoys for the protocol - Jumper T12 will be in charge from now on .

C) Emax Baby Hawk
1) XM Rx soldered in place
2) Firmware tuned
3) Tx @ 40 Expo / 60 Rates - Nice ....
4) 2 Batteries so far indoors
5) Still need to tune FPV goggles to the Emax

D) Being restricted by the weather to indoor RC , Ripit Rev2 is on it's way .
Moving along rather quickly compared to Rev1
Ammmmm ,

Wing is made up of two layers of Depron (3mm ) glued together , with a carbon spar ( .5 x 3mm )
Wing came out @ 17.2 grams after laminating film applied .
Wow , thats more than I wanted .

Next micro DLG HAS TO BE Balsa !!! ....
But I will take the Rip Rev2 to completion .. One needs the practice .

Oh - 3 Days till Christmas ( Xmas for some )
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools