Thread Tools
This thread is privately moderated by japim, who may elect to delete unwanted replies.
Dec 10, 2018, 10:48 AM
Registered User
japim's Avatar
Thread OP
Discussion

3D LabPrint Me109 maiden + crash = deatomization


A friend of mine finished his Me 109 model from 3D Lab Print.
He was a very good R/C Combat flier, but haven't flown for couple years already.
Me 109 from 3D LabPrint was supposed to be his come back.
Weather was very bad for flying - rain + wind. White model on grey sky.
But he was very determined to make the maiden flight either way.

Maiden was OK.
Second flight was not so much OK...
3D LABPrint Me109 maiden + crash (3 min 4 sec)
Last edited by japim; Dec 10, 2018 at 11:01 AM.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools