By the way, the counter with zero was firmware 2.0 in Jeti Exbus.

Originally Posted by Edgar Perez

Jim
Thanks for the clarification. It was a short test, so can’t say it will always be zero. I have another plane using XPS in UDI and the counter is like a clock!
With that said, can you address the difference between each receiver counter and the total one? Is the packet lost indicated by the total counter the one that I will experience while flying ?
Thanks

Wow... that is the opposite of normal because UDI doesn't report frame loss, at least with a single receiver!

Frankly, based on what I have seen with numerous JETI systems, I wouldn't trust it to fly anything until they release the firmware update to fix everything.

Jim
Still want to understand what is the meaning of the Total lost frame counter being lower than the individual counter for each receivers.
Is the total counter the real impact to the plane?

Yes, that total is the real impact to the aircraft... however, that will actually start to increase over a period of time, and not remain 0.

The best solution so far seems to be to NOT use the dual path mode (use "Default" instead) and clone the receivers. That results in lowest number of actual packets lost.

Does any of this also impact the x10+ in udi mode from the jeti rx's?

From what I can tell, no - because JETI UDI doesn't report any packet loss that is occurring. You just have to make sure that you are using 14ms for the frame rate - nothing else will work.

I think you meant to write 14ms

Ack! You are correct. 17ms is default value.

So, if I use UDI with JEti am I safe to fly?

Well, it is proven by myself and jwcraven that packet loss is constantly occurring with the JETI system in all modes, but ExBus is the only one that actually shows the loss. "Safe" is subjective, but using two or more receivers will yield the best results.

So what's the verdict, I have the DS16 with the XPS24 to go into a 35% Extra. Has there been a software/firmware update to address this issue?

I think it is what it is. Jeti losses frames and XPS tell you it’s happening.
No issues in many flights for me. I always use at least two receivers.

That is correct. It's always losing frames and the X24 tells you how many.