Thread Tools
This thread is privately moderated by japim, who may elect to delete unwanted replies.
Oct 29, 2018, 05:28 AM
Registered User
japim's Avatar
Thread OP
Discussion

Making a reinforced Runcam Sparrow FPV cam case


This time something different.
Something at the edge of engineering/modelling/3D printing and FPV.
A short movie showing and discussing the Runcam Sparrow Micro reinforced case and the 2 tricky parts: 1. hot soldering iron brass insert installation & 2. lens thread tapping.

Runcam FPV camera reinforced case with brass inserts and thread (14 min 20 sec)
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Mini-Review GepRC GEP-MX3 "Sparrow" 139mm FPV Racer - F3, RunCam CCD, DShot600, 250mW (review) SoloProFan Micro Multirotor Drones 173 Jul 20, 2019 04:11 PM
New Product Runcam Micro Sparrow & Runcam Sparrow - 2.1mm 145/150 Degree FoV 16:9 CMOS Cameras D Gains FPV Equipment 25 Jun 11, 2018 07:15 AM
New Product RunCam Sparrow FPV Camera 2.1mm FOV150 16:9 OSD / Audio Justapoke FPV Equipment 1 Sep 12, 2017 01:04 PM