Thread Tools
Oct 02, 2018, 04:29 PM
Registered User
Discussion

Connecting MPA to charger using 6s JST XH connection wires


Hello. Just occasionally obtained MPA without PowerLab charger and now wondering, will it be safe to use it with my current charger which has only up to 6s just xh balance port? All stated above assumes that I will keep the position of - wire on 6s balance cord fitting the same as it was on 10s xh.
Sign up now
to remove ads between posts


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion OK to extend the JST-XH balance plug wires another few inches? G.F. Beurling Batteries and Chargers 13 Nov 19, 2016 10:35 AM
Discussion Using a Parallel Charge Board for JST-XH & EC3 with a Hyperion Charger PumpinIron Batteries and Chargers 2 Aug 12, 2016 03:39 PM
Discussion convert 3s jst-xh balance plug to poyquest style ? just switch wires? tic Batteries and Chargers 2 Jul 16, 2016 03:22 AM
Discussion FMA JST-PA female to JST-XH or cut the wires and put on JST-XH, how? markm75 Batteries and Chargers 4 Nov 23, 2015 06:09 PM
Question Possible to charge 2S1P LiPo with JST using charger with JST-XH? engineMagnet Batteries and Chargers 1 Aug 17, 2013 06:07 PM