Thread Tools
Old Dec 26, 2004, 03:50 PM
NickLatech is offline
Find More Posts by NickLatech
Registered User

etching/engraving PCB via a small CNC


I do alot of prototyping for our robot team at Latech. I would like to build a small CNC or engraver so I can make some PCB.

I came here because of a reference so I was hoping someone could help me.

Some places I have found that have these kits are

Stepperworld.com ( FET-3 )
hobbycnc.com ( http://www.hobbycnc.com/cncpackages/...g/4aupcpkg.htm )

These are the motors and drivers, but are these good kits? Where do I get the rails for the table?

Thanks,
Nick
Sign up now
to remove ads between posts
Old Dec 26, 2004, 07:08 PM
NickLatech is offline
Find More Posts by NickLatech
Registered User
I found a XY table on ebay http://cgi.ebay.com/ws/eBayISAPI.dll...sPageName=WD1V

if I use this with a electronics kit from say hobbyCNC.. that would be pretty close to a complete setup? All I would have to add would be a Z travel.

Let me know what yall think

Nick


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion small CNC job theKM The Builders Workshop 6 Aug 17, 2006 02:28 AM
Photo Etching - a "How To" for PCB boards and making small metal parts. planeman Scratchbuilt Indoor and Micro Models 81 Jan 04, 2006 03:49 PM
See small cnc router F/S Landarts The Builders Workshop 4 Jun 17, 2004 11:04 AM
Anyone interested in buying a small cnc router Landarts The Builders Workshop 3 May 14, 2004 09:04 PM