Thread Tools
This thread is privately moderated by Rups63, who may elect to delete unwanted replies.
Jun 17, 2018, 03:38 PM
I'd be mad without a Taranis!
Rups63's Avatar
Thread OP
Discussion

Parkzone Artizan - Night Flyer Mod


Picture of wing halves taken apart.
Last edited by Rups63; Jun 25, 2018 at 11:35 PM.
Sign up now
to remove ads between posts
Jun 30, 2018, 01:12 AM
I'd be mad without a Taranis!
Rups63's Avatar
Thread OP
Finished Nightizan.
Jul 05, 2018, 11:46 AM
Registered User
EvanM's Avatar
Going to do this. How did you separate the two wing halves?
Jul 05, 2018, 11:55 AM
I'd be mad without a Taranis!
Rups63's Avatar
Thread OP
I used a long, fresh, sharp hobby knife (the kind you can break the tips off of when they wear out). I carefully ran it along the seam of the wing halves until I had broken most of the glue free, as deep as I could bury the knife and still hold onto it. The plywood spar is glued in pretty good. I just carefully pried the wing halves apart until they gave. The process wrinkled the decals somewhat. But in my case, I was taking apart an old, beat-up ArtiZan and didn't much care. And, in the dark, you can't tell anyways!
Jul 05, 2018, 11:04 PM
I'd be mad without a Taranis!
Rups63's Avatar
Thread OP
The NightiZan starts at 2:40 in this video my friend made.

Summer Nights (3 min 0 sec)


Full NightiZan footage:

LED plane (2 min 39 sec)
Last edited by Rups63; Jul 05, 2018 at 11:11 PM.


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Airframe recommends for Saturday Slow Night Flyers BrownEyedFool NEAT Fair 2015 19 Oct 01, 2015 06:13 PM
Discussion Futabat9cap mod for Night flyers...! loc_nhim Night Flying 1 May 29, 2010 05:33 PM