Thread Tools
May 21, 2018, 01:03 AM
FRENCH RACER
Discussion

Binding issues with DX20


Hi everyone
I love my X24 units and Jim electronic design is fantastic. But I have been running into issues binding them with my DX20 TX. When I put the X24 in bind mode and then start binding on my TX I get a message complete on the lCD of the X24 but a bind failed message on the DX20

Anyone else with this problem?
Thanks
Sign up now
to remove ads between posts
May 21, 2018, 04:16 PM
Registered User
Delete
Last edited by tande; May 21, 2018 at 05:37 PM. Reason: Not ready to show my ignorance.....
May 21, 2018, 08:23 PM
From your last email, it seems that you are powering on a the main receiver with the satellites attached to the X24. The main receiver is not used at all with the X24. Only the satellite receivers are used. If the X24 says that the bind is complete, then it is complete! The X24's binding won't proceed until the bind is done AND the Tx is outputting valid channel data. It could be that the main receiver (that you shouldn't be using) is confusing the DX-20.


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! Eachine E010s Binding issue with Flysky clone (GoolRC GC6) jacobk123 Beginner Multirotor Drones 3 Apr 26, 2017 04:51 PM
Discussion Eachine F3 EVO with FrSky binding issue techcoast Multirotor Drone Talk 2 Apr 20, 2017 06:14 AM
Discussion Turnigy 9x with Banggood 4in1 module binding issues. Ca_Lee Multirotor Drone Electronics 0 Jan 27, 2017 08:55 AM
Help! Issues with binding Taranis mtrfpv Radios 2 Jul 30, 2016 04:35 PM
Question Binding issue with Corona 2,4 GHz DSSS Futaba System ? Rudi Radios 0 Nov 12, 2015 09:23 AM