|
|
|
|
Thread OP
|
Help!
Moter is not working
Iam following all the steps as follows
1.connect to cleanflight. 2.go to motors and click the 'i understand the risk'. 3.take the master button all the up and the connect the power supply. And after this there is 3 beep sound and then nothing . No sound ,motor also does not worh. Can someone please help me out with this. |
|
|
|
|
|
|
«
Previous Thread
|
Next Thread
»
| Thread Tools | |
| Similar Threads | |||||
| Category | Thread | Thread Starter | Forum | Replies | Last Post |
| Discussion | PPM \ PWM not working on SP Racing F3. Not registering on CleanFLight | R4TS801 | FPV Racing | 25 | May 02, 2020 09:39 AM |
| Discussion | Afro 30A Not Powering moters when Armed? | DavidD | Scratchbuilt Multirotor Drones | 5 | Feb 13, 2018 04:32 AM |
| Discussion | Naze32 and OSDOGE not showing voltage and alarm not working | powellds | Multirotor Drone Electronics | 2 | Jun 07, 2016 02:44 PM |
| Help! | How can i determine maximum power consumpition of BLDC moter if its not specified ? | ayushlabroo7 | Multirotor Drone Power Systems | 7 | Dec 16, 2014 02:47 AM |
| Question | 1 Moter not syncyed after esc calibration | greenmonster182 | Multirotor Drone Talk | 0 | Jul 17, 2013 05:38 PM |