Thread Tools
May 21, 2001, 11:50 PM
Super Senior Member

Ryan Bearcat nearly done :)


I have the fuse and wing glassed and ready for paint. The ailerons, elevator, vertical and horizontal are all sitting in the garage so the primer can dry. I installed the torque rods, but I will take Jim's advice next time and install them prior to glassing. I installed the torque rods through the top of the wing sheeting after glassing, and then filled it over with hobby filler. I am waiting for that to dry so I can sand it lightly even with the wing surface. Then I will hit it with some thin foam safe CA to solidify it and it will be ready for paint. So close......I can nearly hear it buzzing around my field

Greg
Sign up now
to remove ads between posts