|
|
Thread OP
|
Help!
Wiring Help- TattooF4s, RuncamSplit2, TrampHV, X6b
Pretty sure I have this right in the diagram I am posting, but wanted a 2nd opinion as well.
The X6b is running to RX6 so that in Betaflight RX6 can be turned into an iBus port as the F4s is Sbus only. Does everything else look correct? I also included a blank mockup for if I goofed and some kind person would like to draw it out instead of just telling me what I have wrong. Cheers! |
|
|
|
|
|
|
You will need to wire X6B to RX6
You have to use softserial 1 for the split. That means remapping LED and Buzzer to softserial 1 TX and RX. Split TX needs to go to softserial 1 RX and split RX to softserial 1 TX. This means no more buzzer or programmable led. Use Dshot commends to do ESC beeper. You can use static LED by powering through any 5V. Lastly, you need to move Tramp video to the FC VO pin to get OSD. |
|
|
|
You are correct.
|
|
|
Thread OP
|
So I am still having some issues with getting the video working. I am getting OSD but the screen is completely white with the current wiring as follows
I have enabled softserial in configuration and verified that buzzer has been remapped to serial_rx 11 and LED to serial_tx 11. Here is a screenshot of my ports page Thanks in advance, yes I am a noob and tried looking for my answer elsewhere before following up here again. |
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Discussion | Help with Flysky i6x and x6b lipo voltage alarm | Kyza | Radios | 3 | Feb 04, 2019 11:26 PM |
Help! | Flysky I6x binding with X6B receiver help | vondetour | Beginner Multirotor Drones | 6 | Apr 01, 2018 12:25 PM |
Help! | Omnibus V2 Pro/Inav/TrampHV/RuncamSplit2 | Nev1 | FPV Equipment | 19 | Feb 24, 2018 12:28 PM |
Help! | I6x x6b setup help | Spawn7569 | Multirotor Drone Electronics | 0 | Dec 26, 2017 08:24 PM |
Discussion | Need help Connecting CC3D REVO F4 STM32F405 Flight Controller to Flysky x6b | jeeboo374 | Beginner Multirotor Drones | 6 | Mar 07, 2017 06:53 AM |