Thread Tools
This thread is privately moderated by UpNup, who may elect to delete unwanted replies.
Feb 19, 2018, 01:13 PM
Who are these that fly?
UpNup's Avatar
Thread OP
Build Log

Ford Flivver - Balsa Cowl pt 1


The Ford Flivver 268 build from plans is to the point of needing a hatch and cowl. All the electronics are installed and tested except for the two servos underneath. I tried doing just the hatch (see previous blog), but it needed to be integrated with the cowl. I plan to cut away the hatch. I used wax paper to keep glue off the fuselage.

Note: The hatch replaces the one described in the blog posted June 22, 2017.

The photos tell the story. This took about 16 hours.
Last edited by UpNup; Feb 19, 2018 at 01:47 PM.
Sign up now
to remove ads between posts


Quick Reply
Message:
Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Video Beautiful Ford Flivver scale 1:5 BjarneKvilvang Fuel Plane Talk 7 Apr 12, 2018 01:48 PM
Discussion Ford (Stout) 2-AT finished... need 3-view of Ford Flivver Newtron Scale Kit/Scratch Built 6 Jul 02, 2007 08:44 PM