Thread Tools
Feb 16, 2018, 05:10 AM
Registered User
Thread OP

Qx7 SXR setup using LUA script

I am putting together my Bixler and decided to use the Frsky S6R receiver. I watched the Painless360 series and I am stuck at the first calibration screen (photo attached). As recommended I have installed the latest firmware on the receiver and the latest lua scripts on the Tx. When I press enter to start, it takes me to the first (label up) screen but the X,Y,Z, values remain at zero and the “(Enter) to validate” message doesn’t appear. BTW, the radio is bound and AETR all working. I have searched for the answer without success. Any help would be appreciated.
Sign up now
to remove ads between posts
Feb 16, 2018, 06:02 AM
slats move, slots don't
Lots of information is this huge thread:

FrSky S6R 6CH Receiver With 3-Axis Stabilization With Smart Port Telemetry

and great tips from Too Many Toys:

FrSky S6R, S8R, (SXR) Auto Level, Receiver TroubleShooting guide.

Quick Reply

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion F3K program for Taranis QX7 and X9D with scripts for score keeping and graphing jfrickmann Hand Launch 841 Mar 10, 2019 05:24 PM
Download LuaPilot Telemetry Taranis Lua Script ilihack Radios 56 Sep 06, 2018 08:39 AM