Thread Tools
Jan 18, 2018, 03:30 PM
Registered User
Thread OP
Help!

Pixhawk 2.4.8 and EZUHF tx/rx all setup, but doesnt move servo


Hello all,

First, thanks to all of the people on here. I am new to RC and I never would have gotten this far without reading this forum.

Okay, so I have a pixhawk 2.4.8, fully configured, flashed and setup in missionplanner.

I have my RX and TX bound. The pixhawk is communicating with my RX via PPM and i have setup the EXUHF equipment in its software.

When i move the joysticks on my radio, you see the rudder and elevator etc move in Mission planner.

But when i connect a servo or motor, nothing happens.

I have put all of this together on my own with no help from anyone. But I am at a loss and need your help. I just want to see this stuff work before i install into the plane.

The plane this is going in is a Volantex Ranger EX (757-3).

(Side question: Is the Cobra - C3520/12 820Kv Brushless Motor i bought for this too much for this plane? Its the one used on RMRC anaconda, has a similar wingspan, so that is why i went with it.)

Thank you all in advance.

~Jacob
Last edited by LRSFPVTX; Jan 18, 2018 at 03:42 PM.
Sign up now
to remove ads between posts


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Help! pixhawk 2.4.8 elevons move by TX but not by movement. Test Pilot Mafia UAV - Unmanned Aerial Vehicles 0 Jun 10, 2017 02:39 PM
Help! Does any one know how to do a EzUHF video tx + EzUHF Rx 8 ch + EzOSD setup without th ironiic FPV Talk 1 Apr 22, 2016 12:13 PM
Question What is different on the Pixhawk 2.4.8 from the 2.4.5? TheQuestor Multirotor Drone Electronics 2 Apr 15, 2016 10:43 PM
Discussion pixhawk 2.4.6 vs 2.4.8 itsab67 Multirotor Drone Electronics 3 Apr 10, 2016 07:19 PM
Discussion pixhawk 2.4.6 vs 2.4.8 itsab67 Multirotor Drone Electronics 0 Apr 09, 2016 01:17 PM