Thread Tools
Dec 22, 2017, 12:32 PM
Registered User

Micro minimOSD programming

Alright I have a Micro minimOSD and I am having a lot of trouble getting it setup. I've watched several videos on how to set it up but still very confusing. I ended up downloading the Chrome app and I was able to get it flashed and programmed but I am still having the same issue.

I either have clear video with no on screen info OR I have a black screen with the OSD overlay that I setup, never both. Now the clear video usually on comes when I power up the motors and run them for a bit.

I know the FC is communicating with the OSD board because the FC information is displaying correctly on the screen.

This is my setup.

FC = Kingkong Micro Naze32 -

OSD = Micro MinimOSD -

Camera = Eachine 1000TVL 1/3CCD -

VTX = Eachine TX526 5.8 4CH -

I will try to describe the wiring -

OSD and FC powered by the same 5v reg which is powered directly from my 3s battery, grounded together

Camera, VTX powered by the same 12v reg and grounded together

Note: All grounds connect together before either 5v and 12v regs

Any help you can provide would be great and thank you.
Sign up now
to remove ads between posts
Dec 22, 2017, 04:27 PM
I think it's time to fly.
Rhea's Avatar
Look in the Similar Threads below.
Latest blog entry: All things that fly.

Quick Reply

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Honbay CP2102 help programing Micro Minimosd? _Savannah_ FPV Equipment 1 Sep 08, 2017 04:04 PM
Discussion MinimOSD Micro Headaches MA70Snowman FPV Equipment 8 Sep 22, 2016 06:37 PM
Discussion Help! micro minimosd video out pad broke off jcoxpgh Multirotor Drone Electronics 3 Jul 15, 2016 08:42 AM
Question DX7 Micro 4site Brick to Micro Wing Programming TheDonski Scratchbuilt Indoor and Micro Models 12 Nov 04, 2015 07:33 PM
Discussion Programming the minimosd through the 3dr telemtry kit JETNC UAV - Unmanned Aerial Vehicles 1 Jul 21, 2015 08:56 PM