New X10+ coming... - Page 7 - RC Groups
Shop our Airplanes Products Drone Products Sales
Thread Tools
Mar 19, 2018, 05:00 AM
No bounce, No play.
davidmc36's Avatar
The manual describes one way of powering it as splitting an ESC power harness to each end of the servo rails. Gives double the surface area for power input contact.

If I were to try double batteries I would run through a sharing device.

Manual also recommends the large wires as the best input point.
Sign up now
to remove ads between posts
Mar 20, 2018, 07:05 AM
No bounce, No play.
davidmc36's Avatar
Is it normal that the Serial Port seems to have a 'priority' over the Aux Port?

Remote connected to Aux did not want to bind.

With two Remotes connected, when I remove functioning Remote from Aux Port the LED remains Green. If functioning Remote is removed from Serial Port the LED turns Blue.
Mar 20, 2018, 10:31 PM
This is normal. The Serial Port is checked first for valid data and when none is found then the AUX port is checked. With 2.4GHz systems you either get GOOD data or NO data. So, it makes it very simple to check redundancy. You just start with the first receiver and go down the line until you have good data. The X24 works the same way, but it has 4 ports.
Mar 21, 2018, 07:52 AM
No bounce, No play.
davidmc36's Avatar
Roger. All is well with my unit then.

You just need to bind one Rx at a time on Serial Port, no sweat.
Apr 04, 2018, 09:29 PM
Registered User
A sequencer was mentioned in the first post. What are its features?
Apr 05, 2018, 09:05 PM
This is a separate product from the X10+, but it uses the same board. No information is being released yet.
Apr 08, 2018, 08:35 AM
Registered User

Jeti questions for new X10+ V2


Sir,

I ordered, and should have in hand shortly one of your new X10 +V2 expanders.

Having read the manual, I still have a couple of questions...

What protocol for input with Jeti receivers?
Does the V2 accept PPM input? Or will that be a future firmware change?

Also, will the Jeti telemetry work?

Thanks in advance,

Tim Beghtol
Apr 08, 2018, 10:38 PM
JETI UDI is XBUS MODE B.

V2 does not yet support PPM.

JETI telemetry is handled by the receiver, not the X10+.
Apr 09, 2018, 09:19 AM
Registered User
Jim,

Thank you for the reply. I appreciate the straight info direct from the source.
I will be using the X10+ V2 to get the hang of the system.

Anxiously awaiting the next run of X24 so I can convert my other airframes!
Apr 09, 2018, 07:53 PM
The X24 boards are in production, but it is going to be a couple of weeks before we have them in house.


Quick Reply
Message:

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion FrSky - New - Horus X10 and X10S Jet_Flyer Radios 8037 Today 10:53 PM
New Product New FrSky QX7S, X10 and X10S dartita Gearbest.com 16 Mar 17, 2018 02:04 PM
News Bro RC Bodyboarder Coming 2018 Jason Cole Dock Talk 10 Nov 07, 2017 08:25 PM
Discussion New multicoper regulations in Germany (soon to come) CyberCrash Model Aircraft & Drone Advocacy 44 Apr 11, 2017 03:10 PM