Thread Tools
Feb 22, 2002, 06:10 PM
Registered User
Doc Watson's Avatar

Can I use the 7th channel on my RX with a 6 channel Tx

I've seen a thread similar to this but cannot locate

I've got a 6 channel TX and a 7 channel RX I want to be able to use the 7th channel.

It will controlled by using a switch which will operate when another servo starts to move (lets assume its the flaps ).

So when the flaps start moving (using a dial on my TX) a switch will be activated (its actually a computer mouse button switch) and I want it to activate a servo which will travel from full closed to full open (it will open a 'door' like an undercarriage door)

Can this be done in some way??????

(I've plugged in the 7th channel servo and it growls at its end point.)

Cheers guys

Sign up now
to remove ads between posts
Feb 22, 2002, 08:07 PM
Registered User
No, sorry! With some fancier Tx's you can set them up to use channel 5 or 6 in a channel limited Rx with channel 7 or 8 on the Tx but if the Tx doesn't put out a signal on channel 7 you are SOL.
Feb 22, 2002, 11:34 PM
Registered User
Mr.RC-CAM's Avatar
Can this be done in some way?
Yes. You need a "Gear & Door Sequencer" such as sold by

This does not need a seventh channel. It is slaved off an existing gear channel.

Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Discussion Can i use a synth tx module and a regular rx with crytsal? highace1 Radios 6 Sep 24, 2006 11:15 AM
Can I use a 3cell LiPo on my 2cell heli !? liteglow Micro Helis 5 Jul 31, 2005 02:22 PM
Can i use this esc on my Corona ebonicrobot Electric Heli Talk 3 Mar 12, 2005 05:14 PM
Can I turn off the Govenor on my Smile 40-6-12? CheChe156 Electric Heli Talk 4 Mar 03, 2002 01:28 PM
Tail Blades? Can I use Eco8 Blades on my V-E? CheChe156 Electric Heli Talk 4 Mar 02, 2002 12:20 AM