Look REAL close on the circuit board and it should have thing printed on it that gives you the clue. With the four connectors that are right next to each other you'll see an 'E' and an 'R' for elevator and rudder. You will also see a '+' and a '-' for the battery connections (REAL important that you plug the batteries only into these receptacles and in the postive in the postive and the negative in the negative) The other two on the parameter of the circuit board are for your motor. Just plug the motor in and see if it turns the right way. If not switch the wire around. The receptacly in the center is for the atenna. Hope this helps.
If you feel you still need the diagram I will email it to you when I get home. Just send me a reminder to firstname.lastname@example.org
|Category||Thread||Thread Starter||Forum||Replies||Last Post|
|has anyone seen a "Y" harness wire diagram?||daveoner||Batteries and Chargers||11||Feb 23, 2004 08:57 PM|
|RFS-100 receiver channel||bps||Scratchbuilt Indoor and Micro Models||1||Dec 13, 2002 09:46 PM|
|14" Tomahawk RFS-100||Inari||Scratchbuilt Indoor and Micro Models||15||Jul 03, 2002 07:55 AM|
|CR-2 lithiums with RFS-100||fritts||Scratchbuilt Indoor and Micro Models||6||Mar 19, 2002 11:35 AM|
|RFS-100 isn't working for me?||Crasher||Scratchbuilt Indoor and Micro Models||29||Mar 14, 2002 12:01 AM|