Thread Tools |
This thread is privately moderated by flyandride, who may elect to delete unwanted replies. |
|
|
|
Discussion
More success in Polycarbonate, 205 mm
This is a recent successful build in grey and clear polycarbonate. 205 mm. Bottom plate is 3/16, top is ⅛ inch
DYS 1806 2300 kv motors, 4045 BN props, DYS F20A 4 in 1 ESC, BeeRotor F4 flight controller, X4RSB receiver, Airgain PCB antennas, TBS Unify Pro HV, Runcam Eagle 2 camera with HS35HD tilt servo, Far Vew Pagoda antenna. Betaflight 3.2.0 and Dshot 600. I mounted the Unify Pro HV to a sheet metal heat sink with heat conductive silicone mat. A 1000 uF capacitor is between the rear center standoffs. It flies well and video is clear. Taranis lua script for changing PID, rates and vtx settings. Weight is 300 grams without battery. |
|
|
|
|
Thread Tools | |
Similar Threads | |||||
Category | Thread | Thread Starter | Forum | Replies | Last Post |
Mini-HowTo | Bringing more success to your questions in three steps. | UserName Here | Beginner Training Area (Fuel) | 25 | Jan 21, 2023 10:37 AM |
More Power in the MM C-180! | Jack Haker | Parkflyers | 8 | Jan 13, 2003 02:33 PM |