Lumenier RB2205C-12 2400KV SKITZO Ceramic Bearing Motor
Thread Tools
Old Oct 26, 2004, 12:18 PM
e-geezer is offline
Find More Posts by e-geezer
Up faster, higher, longer
e-geezer's Avatar
You could get more thrust and less speed by using (a prop with less pitch) and/or (a lower voltage battery with perhaps a slightly higher pitch prop to bring the current back up).
Sign up now
to remove ads between posts
Old Oct 26, 2004, 06:55 PM
Dave T is offline
Find More Posts by Dave T
Registered User

cd power


I think that I have the lowest pith prop I can buy. Sorry I din't tell the amps The Double 22.7mm motor draws 12amps at 11 volts with the 10x3.8 prop
I think I will have to rewind the motor with a smaller gadge wire mabee 26gwire and more winds mabee 20 turns then check amps and posibly go with a 11x3.8 or 11x4.7 prop. I will try to do that in the next week and post the results. Thanks
Old Oct 27, 2004, 05:55 AM
e-geezer is offline
Find More Posts by e-geezer
Up faster, higher, longer
e-geezer's Avatar
I meant to say:

You could get more thrust and less speed by using (a prop with less pitch) and/or (a lower voltage battery with perhaps a slightly higher diameter prop to bring the current back up).

Also, using more turns of thinner wire will take less power for the same battery. You'd then need an even bigger prop for the same power. I'd just go for a larger diameter, lower pitch prop. Keep increasing the prop diameter until the current is too high then go back a size.
Old Sep 21, 2014, 04:32 AM
The Hung is offline
Find More Posts by The Hung
Registered User

Velineon 380 overheating.


I tried to mod may J3 cub by using a velineon 380 with an 8040 prop. it was very powerful, but didn't last long d/t overheating. Can anyone help me solve this problem. Should I change the battery (current 11.1v 2200) or the prop?


Thread Tools

Similar Threads
Category Thread Thread Starter Forum Replies Last Post
Idea Successful Power Systems jrb Power Systems 586 Nov 06, 2016 12:26 PM
Successful Power Systems sandburr Power Systems 0 Jul 31, 2005 07:57 PM
Successful Power Systems II superflyX Power Systems 0 May 19, 2005 12:47 AM
Another question from Successful Power Systems helisfreak Power Systems 1 Apr 16, 2004 11:28 AM
Discussion removed from Successful Power Systems thread SharksTooth Power Systems 4 Apr 15, 2004 12:45 PM